OctoTariffs

Meters and readings

Octopus bill looks wrong after a meter exchange: how to put it right

Why an Octopus bill can go wrong after a new meter is fitted, how to check the readings, what a rebill looks like, and how to complain and escalate.

Edited by Rob Gibbs. Published: . Guidance reviewed: .

Methodology · Corrections

Short answer

A bill that looks wrong after a meter exchange usually comes down to the readings: the final reading from the old meter, the first one from the new meter, two Economy 7 registers the wrong way round, or estimates while the new meter connects (Octopus allows up to 14 days). Check the readings on your statement against the meter, send Octopus dated photos and ask it to rebill. If that does not fix it, complain; after 8 weeks, or sooner with a deadlock letter, you can go to the Energy Ombudsman for free.

What should happen when Octopus swaps your meter

Before taking the old meter away, the engineer reads it and puts that reading into Octopus’s system. That closing reading ends the old meter’s billing, and the new meter counts from its own figure, which has nothing to do with the old one. Octopus says the swap takes about an hour for each fuel, with the power off for around half an hour.

A new smart meter can then take up to 14 days to connect to Octopus. Until it does, Octopus cannot read it remotely, so your account may show estimates and you may get a reading-request email. Octopus says you can ignore that request, because the engineer has already taken the final reading from the old meter. If the new meter is still not showing in your account after 14 days, contact Octopus.

Why the bill can come out wrong

Most problems after an exchange trace back to one of these:

  • The old meter’s closing reading is missing, mistyped or estimated, so the last stretch on the old meter is billed on a guess.
  • Readings from the two meters have been run together, so the gap between an old reading and a new one looks like a huge amount of use, or a negative one.
  • On a two-rate meter such as Economy 7, the day and night registers have been swapped, which bills cheap-rate units at the day rate or the other way round.
  • The new smart meter has not connected yet, so you are billed on estimates for those first weeks.
  • You have a statement for only one fuel: Octopus does this while it investigates a reading that did not look right, or when it has stopped getting automatic smart readings.

Check the readings on your statement

Open the PDF statement: the meter readings are on page two. Each one is marked “Estimated” or “Customer read”, so you can see which figures were guesses. Find the date of the exchange and check that the old meter’s last reading and the new meter’s first reading are both there, and that they are listed against different meters.

Then compare the new meter’s display with the latest reading on the bill. If you have Economy 7, Octopus suggests a simple test to tell the registers apart: photograph the meter between 8am and 11pm and again an hour later, ideally with a clock in shot. The register that moved is the day one. Keep these photos, and any you took of the old meter on the day it was swapped: they are your evidence.

What a corrected bill (rebill) looks like

When Octopus finds a past bill was based on a wrong reading, it reverses the old charges and works them out again. On your statement that shows as a “reversed account charge” among the credits on page one, followed by the corrected charges. It can look alarming, but it is the fix in progress.

If the corrected figures are lower, the difference comes back to your account as credit. If the estimates were too low, the correction can mean a higher bill. Octopus says that after you send a correct reading it typically creates a new bill within 48 hours. If something still looks wrong after that, ask Octopus which readings it used and why.

Catch-up bills and the 12-month rule

If a mix-up meant you were undercharged for a long time, you may be asked to pay the difference. Ofgem’s back-billing rules limit that: you do not have to pay for energy used more than 12 months ago if you were never correctly billed for it, unless you acted unreasonably, for example by blocking access to the meter. Octopus’s own terms say it will not try to recover charges older than 12 months in that situation. If a back bill reaches further than that, say so when you contact Octopus.

How to complain, and when to go to the Energy Ombudsman

Start by contacting Octopus with your account number, the date of the exchange, the readings you believe are right and your photos. Its complaints team is at issueresolution@octopus.energy. Keep a note of every contact, with dates.

If Octopus cannot resolve it, it sets out its view, makes a final offer and, if you turn that down, sends a deadlock letter. You can take the complaint to the Energy Ombudsman once you have that letter, or once 8 weeks have passed since you complained. The Ombudsman is free and independent; its decision binds Octopus but not you, and it can require an explanation, an apology, corrective action or compensation. You must go to it within 12 months of a deadlock letter. Citizens Advice gives free, independent advice at any stage.

Questions people ask

Why is Octopus asking for a meter reading just after my new meter was fitted?

A new smart meter can take up to 14 days to connect to Octopus, and the usual reading-request email can go out in the meantime. Octopus says you do not need to reply, because the engineer took the final reading from your old meter. If you are still being asked more than 14 days after the installation, get in touch with Octopus.

My first bill after the exchange shows a huge amount of energy. What has gone wrong?

Usually the old meter’s closing reading and the new meter’s opening reading have been treated as if they came from one meter, or the closing reading was estimated. Compare the readings on page two of your statement with your photos and the new meter, then send Octopus the correct figures. It reverses the wrong charges and rebills.

What does “reversed account charge” mean on my Octopus statement?

Octopus found a problem with a past bill, for example one based on a wrong reading. It has removed the incorrect charges, credited your account so it is back to square one, and then added the corrected charges. If the corrected total is lower, you keep the difference as credit.

How can I tell if my day and night readings were swapped on the new meter?

Octopus suggests photographing the meter between 8am and 11pm and again an hour later, ideally with a clock in the picture. The register that has moved is the day (peak) one. Email the photos to Octopus and it will correct any readings that were mixed up.

Do I have to pay a large catch-up bill after a meter mix-up?

Possibly for recent use, but Ofgem’s back-billing rules mean you usually do not have to pay for energy used more than 12 months ago that you were never correctly billed for, unless you acted unreasonably, such as blocking access to the meter. If the bill is genuine but hard to pay, ask Octopus about spreading the cost.

Why has my bill only got electricity (or only gas) on it since the exchange?

Octopus sends a single-fuel statement while it investigates a reading for the other fuel that did not look right, or when it has stopped getting automatic smart readings. If you have a smart meter and the missing fuel does not reappear, or no statement arrives for a while, contact Octopus.

How long does Octopus have to fix a billing complaint before I can go to the Ombudsman?

Eight weeks from your complaint, or less if Octopus sends a deadlock letter saying it cannot do any more. After that you can register the dispute with the Energy Ombudsman for free, online, by post, by email or by phone. If you have a deadlock letter, you must go to the Ombudsman within 12 months of it.

Could the new meter itself be faulty?

It is possible but rare: most problems after an exchange are about readings, not meters. If you have ruled out reading errors and still think the meter is wrong, contact Octopus. It can investigate, and says you will never be overcharged because of a faulty meter.

Primary sources

  • Getting a smart meter installed: what you need to know — Octopus Energy; checked 2026-11-14. Checked 14 November 2026: the engineer takes readings from the existing meters and adds them to Octopus’s system before swapping them; the install takes about an hour per fuel, with the power off for around 30 minutes; the new meter goes in the same place and the old one is taken away; reading requests while the new meter connects can be ignored.
  • How long will it take my smart meters to connect after installation? — Octopus Energy; checked 2026-11-14. Checked 14 November 2026: it can take up to 14 days for Octopus to connect to new smart meters and the in-home display after installation; until then it cannot take automatic readings. A reading-request email in that time can be ignored because the engineer took the final reading from the old meter. Contact Octopus if the meters are not showing after 14 days.
  • How to read your Octopus Energy bill — Octopus Energy; checked 2026-11-14. Checked 14 November 2026: a single-fuel statement can mean Octopus is waiting for a reading or investigating one that did not look right, or that it has stopped getting automatic smart readings; a “reversed account charge” means past charges were removed and recalculated, for example after billing to a wrong reading; a corrected reading produces a new bill, typically within 48 hours; readings on page two of the PDF statement are marked “Estimated” or “Customer read”; after three months without real readings Octopus bills on an estimate; Octopus says it ensures you are never overcharged because of a faulty meter.
  • I have an Economy 7 meter - how do I tell my off-peak (night) reading from my peak (day) reading? — Octopus Energy; checked 2026-11-14. Photograph the meter between 8am and 11pm, then again an hour later, ideally with a clock in shot; the register that moved records peak (day) use. Mixed-up registers can lead to overcharging, and Octopus corrects them from emailed photos.
  • What to do if you get a back bill — Ofgem; checked 2026-11-14. You do not have to pay for energy used more than 12 months ago if you were never accurately billed or told about it, or your Direct Debit was set too low, unless you acted unreasonably, for example by blocking access to the meter. Contact the supplier, then complain if it keeps asking for payment.
  • Domestic energy supply terms and conditions — Octopus Energy; checked 2026-11-14. General domestic tariff, meter, pricing, switching and referral terms. Updated 20 October 2026: prices do not change during a fixed rate tariff; reasonable notice of changes not to the customer’s advantage, including higher charges or a smart-tariff formula change, with the right to switch tariff or supplier without penalty. Checked 14 November 2026, section 5 (rights of cancellation): you may cancel by email or on the website within 14 days of submitting your application (the cooling-off period); if you cancel in that time you pay for supply from the Supply Start Date until your new contract starts, Octopus cannot stop you switching elsewhere and cannot charge exit fees; no exit fee in the final 49 days of a contract; after the supply date you can take a new Octopus contract, an equivalent contract with your previous supplier, or another supplier, and after 15 working days without action you move to a Deemed Contract. Clause 8.9: Octopus will not try to recover energy charges older than 12 months unless it already tried to, or you behaved obstructively or unreasonably. Clause 18: complaints follow octopus.energy/unhappy; after a deadlock letter or eight weeks you can refer the issue to the Energy Ombudsman.
  • Something not right? (complaints process) — Octopus Energy; checked 2026-11-14. Checked 14 November 2026: email issueresolution@octopus.energy, call, or write; if no resolution is reached, or the complaint has been open for 8 weeks, Octopus explains its view, makes a final offer and, if you decline, issues a deadlock letter for the Energy Ombudsman. The Ombudsman service is free and independent, can require an explanation, apology, actions or compensation, and its decision binds Octopus but not you. Citizens Advice gives free independent advice.
  • Our process — Energy Ombudsman; checked 2026-11-14. Checked 14 November 2026: complain to the energy company first; it has 8 weeks to resolve the complaint. With a final decision or deadlock letter, or after 8 weeks, you can register the dispute free online, by post, email or phone. You must escalate within 12 months of a deadlock letter. Once you accept a decision, the supplier is legally bound to carry it out, within 28 days.
  • Contacting your energy supplier about a problem — Citizens Advice; checked 2026-11-14. Contact the supplier first and keep a record, gather evidence such as photos and bills, then complain. You can go to the Energy Ombudsman with a deadlock letter, or if there is no decision after 8 weeks.